man 3c5x9setup (Administration système) - setup program for the 3Com 3x9 cards.

NAME

3c5x9setup - setup program for the 3Com 3x9 cards.

3c5x9setup [options]

3c5x9setup is a program that you can use to setup 3Com 3c5x9 series ethercards.

These programs follow the usual GNU command line syntax, with long options starting with two dashes (`-'). A summary of options is included below.

-h, --help: Show summary of options.
-v, --version: Show version of program.
-V, --verbose: Verbose mode
-D, --debug: Show Debug messages
-a, --all: Print all registers
-p, --base-address <port>: Specify port to use
-E, --emergency-rewrite: Re-write a corrupted EEPROM
-f, --force-detection: Force if card is busy
-F, --new-interface <type>: Interface type to be used. This can be 10baseT, 10base2 or AUI.
-P, --new-IOaddress, --new-base-address <port>: New base I/O address
-H, --new-hwaddress <addr>: New base hardware address
-Q, --new-irq <irq>: Specify interrupt number
-w, --write-EEPROM <values>: Write to the EEPROMS with the specified values.

This manual page was written by Alain Schroeder <alain@debian.org>, for the Debian GNU/Linux system (but may be used by others).