al1700-diag - Diagnostic program for the Allied Telesis AT1700

al1700-diag [options]

al1700-diag is a diagnostic program for the Allied Telesis AT1700, and similar boards built around the Fujitsu MB86965. It does not test every possible hardware fault, but it does verify the basic functionality ofthe board.

These programs follow the usual GNU command line syntax, with long options starting with two dashes (`-'). A summary of options is included below.

-h, --help

Show summary of options.

-V, --version

Show version of program.

-v, --verbose

Verbose mode.

-q, --quiet

Be very unverbose.

-a, --all

Print all registers.

-e, --show-eeprom

Dump EEPROM contents to stdout.

-p, --base-address <port>

Specify port to use.

-F, --new-interface <interface>

Interface number. Options that make sense are: 10baseT, 100baseTx, 10baseT-FDX, 100baseTx-FDX, 100baseT4, 100baseFx, 100baseFx-FDX, MII and Autosense.

-P <address>

Set card to a new IO base address.

-Q <irq>

Set card to a new IRQ.

-m, --show-mii

Dump MII management registers.

-r, --reset-ASIC

Reset the ASIC.

-m

Tests multicast.

-w, --write-EEPROM <values>

Write to the EEPROMS with the specified values. Do not use this, if you do not know what you do!

mii-diag(8)

This manual page was written by Alain Schroeder <alain@debian.org>, for the Debian GNU/Linux system (but may be used by others).