atlantic-setup - Setup program for ethernet cards based on AT/LANTIC DP83905 chips.

atlantic-setup [options]

atlantic-setup is a setup and diagnostic program for ISA NE2000 Ethernet adapters. It has specific support for configuring the National Semiconductor AT/LANTIC DP83905 used in on ISA Ethernet adapters such as the NE2000plus. It also works several work-alike chips from other vendors.

These programs follow the usual GNU command line syntax, with long options starting with two dashes (`-'). A summary of options is included below.

-h, --help

Show summary of options.

-V, --version

Show version of program.

-v, --verbose

Verbose mode.

-q, --quiet

Be very unverbose.

-a, --all

Print all registers.

-N, --NE2000

Set card to NE2000 mode.

-W, --wd8013

Set card to WD8013 mode.

-p, --base-address <port>

Specify port to use. Valid values are: 0x240, 0x280, 0x300, 0x320, 0x340, 0x360 (default: 0x300).

-P, --new_ioport <port>

Set card to use new port. Valid values are: 0x240, 0x280, 0x300, 0x320, 0x340, 0x360 (default: 0x300).

-F, --interface <interface>

Interface number. Valid Options are: 10baseT, 10base2, 10base5, AUI.

-Q, -i, --irq <irq>

Specify new interrupt. Valid values are: 3-5,9-12,15.

-w, --write-EEPROM <values>

Write to the EEPROMS with the specified values.

mii-diag(8)

This manual page was written by Alain Schroeder <alain@debian.org>, for the Debian GNU/Linux system (but may be used by others).