hp+-diag - Diagnostic program for HP 100VG vetwork adaptors

hp+-diag [options]

hp100vg-diag is a diagnostic program for the HP 100VG Ethernet adapter using the Lucent ATT2MD01 chips. You can use this program to diagnose problems with your enternet adapters.

These programs follow the usual GNU command line syntax, with long options starting with two dashes (`-'). A summary of options is included below.

-h, --help

Show summary of options.

-V, --version

Show version of program.

-v, --verbose

Verbose mode.

-D, --debug

Debug mode.

-a, --show_all_registers

Print all registers.

-e, --show-eeprom

Dump EEPROM contents,

-m, --show_mii

Print the MII transceiver state Using -mm monitors the link.

-f, --force

Perform operation, even on a running NIC.

-p, --port-base <port>

Specify port to use. Valid values are: 0x240, 0x280, 0x300, 0x320, 0x340, 0x360

-#, --card_num <number>

Operate on the specified card index.

-t, --chip-type <type> Specify adapter type with '-p', use '-1' to list.

-G, --parameters <parms>

Write adapter-specific parameters in the persistent EEPROM settings.

-H, --new-hwaddr 01:23:45:67:ab:cd

Set a new hardware station address. Typically diabled.

-B

Show the first few bytes of the ROM

-L <file>

Load the Flash from FILE.

-S <file>

Store the Flash image to FILE.

-w, --write-EEPROM <values>

Write to the EEPROMS with the specified values.

mii-diag(8)

This manual page was written by Alain Schroeder <alain@debian.org>, for the Debian GNU/Linux system (but may be used by others).