man breakpoint_client (Commandes) - a tool to connect to a Ruby/Breakpoint service

NAME

breakpoint_client - a tool to connect to a Ruby/Breakpoint service

SYNOPSIS

breakpoint_client [options] [server uri]

DESCRIPTION

This tool lets you connect to a Ruby/Breakpoint service which was started via Breakpoint.activate_drb.

The server uri defaults to druby://localhost:42531

OPTIONS

-c, --client-uri=uri
Run the client on the specified uri. This can be used to specify the port that the client uses to allow for back connections from the server (default: find a good URI automatically). Example: -c druby://localhost:12345
-s, --server-uri=uri
Connect to the server specified at the specified uri (default: druby://localhost:42531).
-R, --retry-delay=delay
Automatically try to reconnect to the server after delay seconds when the connection failed or timed out. A value of 0 disables automatical reconnecting completely (default: 10).
-P, --[no-]permanent
Run the breakpoint client in permanent mode. This means that the client will keep continue running even after the server has closed the connection. Useful for example in Rails (default: non-permanent).
-V, --[no-]verbose
Run the breakpoint client in verbose mode. Will produce more messages, for example between individual breakpoints. This might help in seeing that the breakpoint client is still alive, but adds quite a bit of clutter. (default: non-verbose).
-h, --help
Show this help message.
-v, --version
Display the version information.

SEE ALSO

The Ruby/Breakpoint website on http://ruby-breakpoint.rubyforge.org/ (has FAQ!).

AUTHOR

Ruby/Breakpoint was written by Florian Gross <flgr@ccan.de>

This manual page was written by Paul van Tilburg <paulvt@debian.org> for the Debian project (but may be used by others).