dll - A user-program downloader for the RCX.

dll [options] command | {file}.lx

This manual page documents the dll user-program download command.

dll is a program which is used to download user programs written for brickOS to the RCX.

This program follows the usual GNU command line syntax, with long options starting with two dashes (`-'). The options supported by dll are:

(run with no parms)

Show built-in help (summary of options)

-e, --execute

Execute program after download.

-i{0|1}, --irmode={0|1}

Set IR mode (on RCX) to near(0) or far(1)

-p{1-8}, --program={1-8}

Download program to program-slot-number {1-8}

NOTE: LegOS supports 8 program slots where the Mindstorms original firmware only supports 5.

-r{hostaddress}, --rcxaddr={hostaddress}

Send to RCX LNP at host address {0-15}. Default is 0. See also --node={hostaddress}

-s{srcport}, --srcport={srcport}

Send to RCX LNP source port {0-15}

-t{ttydevice} --tty={ttydevice}

Specify serial tty device where IR tower is connected.

NOTE: The environment variable RCXTTY may be used in place of -tty

-v, --verbose

Enable verbose output

-d{1-8}, --delete={1-8}

Delete program from program-slot-number {1-8}

-n{hostaddress}, --node={hostaddress}

Set RCX LNP host address to {0-15}

dll will respond to the environment variable RCXTTY. This should be set to the serial device to which the IR tower is connected. Use of RCXTTY is equivalent the using the -tty command-line option.

dll is a simple command to use. The following examples show most of the uses.

Ex1: download demo/robots.lx to the RCX as program 0.

   $ dll -tty=/dev/ttyS0 demo/robots.lx
   $

Ex2: download the demo/linetrack.lx into program-slot 7. (note we are first setting RCXTTY so we don't have to keep specifying the tty device each download).

   $ export RCXTTY=/dev/ttyS1
   $ dll -p7 demo/linetrack.lx
   $

Ex3: download demo/rover.lx but we are leaving the RCX powered off (assume RCXTTY is already set).

   $ dll -p2 demo/rover.lx
   error deleting program
   $

We'll leave the experiment of running dll with --verbose set as an exercise for you our reader... (This is actually a combination of progress infromation and debug ouput.)

Unfortunately, there is basically only one dll error message, and it applies to most possible errors, including a disconnected IR tower, an RCX that is turned off, an RCX that doesn't have brickOS, and an RCX that has brickOS and is already running a program. So, check all those things when dll fails.

firmdl3(1)

dll was written by: Markus L. Noga.

Addiitonal Contributor(s): everyone discussing LNP at LUGNET

This manual page was written by Stephen M Moraco <stephen@debian.org>, for the Debian GNU/Linux system (but may be used by others).