These are the options used to select the parameters of a print job that are usually controlled on a per job basis.

-c

Force color mode if autodetect doesn't work.

-d0duplex

Duplex code to send to printer [1]. | n l | n l | n l . 1 off 2 long edge 3 short edge

-g0xpixxypix

Set page dimensions in pixels [10200x6600].

-m0media

Media code to send to printer [1]. l l l l n n. _ Media 2300DL 2200DL _ standard 1 1 transparency 2 2 envelope 257 na letterhead 259 na thick 261 4 postcard 262 na labels 263 3

-p0paper

Paper code to send to printer [1]. | n l | n l. 1 letter 9 A4 5 legal 11 A5 7 executive 13 B5

-n0copies

Number of copies [1].

-r0xresxyres

Set device resolution in pixels/inch [1200x600].

-s0source

Source (InputSlot) code to send to printer [7]. 1 upper 4 manual 2 lower 7 auto

-J0filename

Filename string to send to printer.

-U0username

Username string to send to printer.

These are the options used to customize the operation of foo2zjs for a particular printer.

-u0xoffxyoff

Set the offset of the start of the printable region from the upper left corner, in pixels [0x0].

-l0xoffxyoff

Set the offset of the end of the printable region from the lower right corner, in pixels [0x0].

-L0mask

Send logical clipping amounts implied by -u/-l in the ZjStream [3]. l l. 0 don't send any logical clipping amounts 1 only send Y clipping amount 2 only send X clipping amount 3 send both X and Y clipping amounts

-P

Do not send START_PLANE codes on monochrome output. May be needed by some black and white only printers, such as the HP LaserJet 1000.

-A

AllIsBlack: convert C=1,M=1,Y=1 to just K=1. Works with bitcmyk input only.

-B

BlackClears: K=1 forces C,M,Y to 0. Works with bitcmyk input only.

-X0padlen

Add extra zero padding to the end of BID segments. The default is 16 bytes. Padding 16 bytes of zeroes is needed for older ZjStream printers, such as the Minolta 2200DL and HP LaserJet 1000, and seems harmless to newer ones, such as the Minolta 2300DL. So the default should be good for all cases.

These options are used for debugging foo2zjs.

-S0plane

Output just a single color plane from a color print and print it on the black plane. The default is to output all color planes. l l. 1 Cyan 2 Magenta 3 Yellow 4 Black

-D0level

Set Debug level [0].