mattrib - change MSDOS file attribute flags

This manpage has been automatically generated from mtools's texinfo documentation, and may not be entirely accurate or complete. See the end of this man page for details.

CWMattrib is used to change MS-DOS file attribute flags. It has the following syntax:

CWmattrib [CW-a|+a] [CW-h|+h] [CW-r|+r] [CW-s|+s] [CW-/] [CW-p] [CW-X] msdosfile [ msdosfiles ... ]

CWMattrib adds attribute flags to an MS-DOS file (with the `CW+' operator) or remove attribute flags (with the `CW-' operator).

CWMattrib supports the following attribute bits:

CWa

Archive bit. Used by some backup programs to indicate a new file.

CWr

Read-only bit. Used to indicate a read-only file. Files with this bit set cannot be erased by CWDEL nor modified.

CWs

System bit. Used by MS-DOS to indicate a operating system file.

CWh

Hidden bit. Used to make files hidden from CWDIR.

CWMattrib supports the following command line flags:

CW/

Recursive. Recursively list the attributes of the files in the subdirectories.

CWX

Concise. Prints the attributes whithout any whitespace padding. If neither the "/" option is given, nor the msdosfile contains a wildcard, and there is only one Msdos file parameter on the command line, only the attribute is printed, and not the filename. This option is convenient for scripts

CWp

Replay mode. Outputs a series of mformat commands that will reproduce the current situation, starting from a situation as left by untarring the Dos filesystem. Commands are only output for attribute settings that differ from the default (archive bit set for files, unset for directories). This option is intended to be used in addition to tar. The CWreadonly attribute is not taken into account, as tar can set that one itself.

Mtools' texinfo doc

This manpage has been automatically generated from mtools's texinfo documentation. However, this process is only approximative, and some items, such as crossreferences, footnotes and indices are lost in this translation process. Indeed, these items have no appropriate representation in the manpage format. Moreover, not all information has been translated into the manpage version. Thus I strongly advise you to use the original texinfo doc. See the end of this manpage for instructions how to view the texinfo doc.

*

To generate a printable copy from the texinfo doc, run the following commands:

    ./configure; make dvi; dvips mtools.dvi

*

To generate a html copy, run:

    ./configure; make html

A premade html can be found at: CWhttp://mtools.linux.lu and also at: CWhttp://www.tux.org/pub/knaff/mtools

*

To generate an info copy (browsable using emacs' info mode), run:

    ./configure; make info

The texinfo doc looks most pretty when printed or as html. Indeed, in the info version certain examples are difficult to read due to the quoting conventions used in info.