openam - H.323 answering machine

openam [options]...

openam is a simple answering machine using the H.323 protocol. openam works by setting up a H.323 listener process, and then waiting for incoming connections. Whenever an incoming connection is established, it plays the outgoing message (OGM) and then starts recording any incoming audio from the remote end into a record file.

All of the command line options to openam can be specified in long form, and the most commonly used options also have single character equivalents. The long forms can also be used in the openam configuration file.

-d, --directory dir

Set the directory that record files are created in to dir.

-D, --disable codec

Disable the specified codec (may be used multiple times).

-g, --gatekeeper host

Upon startup, register only with the specified gatekeeper rather than attempting to find a gatekeeper by using UDP broadcast.

--g711message filename

Set outgoing message for G.711 codec to filename.

--g7231message filename

Set outgoing message for G.723.1 codec to filename.

--gsmmessage filename

Set outgoing message for GSM codec to filename.

-h, --help

Display the help message.

-i, --interface IP

Only bind to the specified network interface address. By default, openam automatically listens for incoming calls on all TCP/IP network interfaces available on the host machine. This option is useful for running multiple copies of openam on the same multi-homed machine, or for ensuring that only calls from the external, or internal, network will be received on a particular answering machine.

-k, --kill

Kill recorded files after user command.

-l, --limit secs

Limit recorded messages to a duration of secs seconds (defaults to 30).

--listenport port

Listen on the specified tcp port instead of the default 1720.

-m, --message filename

Set outgoing message to filename.

-n, --no-gatekeeper

Do not attempt to find a gatekeeper upon startup using UDP broadcast.

-o, --output filename

Write trace output (enabled with the -t option) to the specified file rather than to stderr.

--pcmmessage filename

Set outgoing message for PCM derived codecs (G.711/GSM) to filename.

-P, --prefer codec

Sets the prefered codec to the specified codec. If used multiple times, it specifies an order in preference, being the first one specified the most prefered one.

--require-gatekeeper

Exit if a gatekeeper cannot be found.

-r, --run cmd

Run the command specified as cmd after each recorded message.

--save

Save arguments in configuration file.

-t, --trace

Enable debug tracing, which displays messages at run-time to assist in debugging or problem identification. Specifying this option multiple times increases the amount of information displayed. Use the -o option to write the trace information to a file rather than to stderr.

-u, --username str

Set the local endpoint name to str. Default is "OpenH323 Answering Machine vxxx".

openam options can be set in the openam configuration file ~/.pwlib_config/openam.ini either by edditing this file or via the --save option. Options must be located in the section prefixed with [Options]. The long form of any command line option specified above can be specified in the configuration file, in the format:

option = value

openam -n -m hello

Start the program without registering with a gatekeeper using message on file hello.sw or hello.g723 depending on the codec.

openam -m sample_message -r new_msg

Start the answer machine searching for a gatekeeper to register with, using the examples "sample_message" and "new_msg" respectively as the answering message and the script to be run after each recorded message.

~/.pwlib_config/openam.ini

None that I know of.

README.txt file in the doc directory.